I just set up my Xcarve, big jump from my fireball v90! Now, in the past, it was Vcarve->Mach3->machine. As XCARVE is Grbl, i wanted to ask, if i do multiple tools in vcarve, and send then to easel and then to the machine, will that work as accurately?
How about vtransfer? Will that work as accurately?
I ask because I'm dying trying to set up UGS.
Eventually i would like to jump to aspire.
Any suggestions for an older fart set um his ways?
Mike
Post Proc question?
-
- Posts: 5
- Joined: Sun Feb 10, 2019 2:59 am
- Model of CNC Machine: Xcarve 1000 by 1000