Post Proc question?

This forum is for requests and queries about machine tool support for Vectric Products
Post Reply
Posts: 5
Joined: Sun Feb 10, 2019 2:59 am
Model of CNC Machine: Xcarve 1000 by 1000

Post Proc question?

Post by KailuaMike »

I just set up my Xcarve, big jump from my fireball v90! Now, in the past, it was Vcarve->Mach3->machine. As XCARVE is Grbl, i wanted to ask, if i do multiple tools in vcarve, and send then to easel and then to the machine, will that work as accurately?

How about vtransfer? Will that work as accurately?

I ask because I'm dying trying to set up UGS.

Eventually i would like to jump to aspire.

Any suggestions for an older fart set um his ways?


Post Reply