ATC Spindle - anybody using this one?

This forum is for requests and queries about machine tool support for Vectric Products
Post Reply
Vectric Apprentice
Posts: 66
Joined: Wed Jul 27, 2011 3:36 am
Model of CNC Machine: 4x4 DIY Router
Location: Starkville, MS

ATC Spindle - anybody using this one?

Post by dbrook »

I am interested replacing my Hitachi router with a spindle and would love to have a tool change spindle. Before I seriously consider dropping that much cash I wanted to check to see if anybody on the forum has had any experience with this ATC spindle. It can be found on the spindle page. ... kl-2200atc

Any input on the spindle and the company would be most appreciated.

See attached picture.


Vectric Wizard
Posts: 1572
Joined: Sun Sep 16, 2007 2:59 pm
Model of CNC Machine: Custom DIY
Location: Shelby Township, MI, USA

Re: ATC Spindle - anybody using this one?

Post by ger21 »

Automation Technologies is a reputable company. However, all they really do is import chinese goods and resell them. If you need support for anything you buy from them, don't expect a lot.

I've only seen one or two people using chinese ATC spindles, and I doubt that they were that exact model. There are a lot of different manufacturers of those spindles.
Gerry -

Posts: 9
Joined: Fri Dec 16, 2016 3:18 am
Model of CNC Machine: Home Made 24x36

Re: ATC Spindle - anybody using this one?

Post by 101179567skltd »

Just interested if you went ahead with this spindle?

I have just purchased one and am now collecting peripherals before starting to hook it up. I was hoping there was someone to clarify a few things along the way.

Post Reply