LinuxCNC/EMC2 Post Processor

This forum is for requests and queries about machine tool support for Vectric Products
Post Reply
marcandkathy
Posts: 1
Joined: Sat Jan 20, 2024 6:31 pm
Model of CNC Machine: HD510

LinuxCNC/EMC2 Post Processor

Post by marcandkathy »

Been using Vectric Pro for several years with our HD510. Just purchased a CNC which requires the subject post processor. Could use advise on getting Vectric to output the proper file to the machine. The "tap" file if you will.

Marc & Kathy

Post Reply