Acorn Post Processor

[fixtureman]

I just tried a centroid post on my new Acorn controller and after the job ended the spindle did not retrack and stayed at the end spot. I am used to the Shopbot post that has the spindle raise up and go home. does anyone have a post for that

[IslaWW]

You can take any lines of code you wish from the SB postP and copy them to the Centroid postP. (with gcode thranslation if needed)

[fixtureman]

Thank you Gary Now I have to find the post processor for aspire 8.5 on a windows 11 machine. it was real easy on my older windows computers but they change names and locations on this one

[IslaWW]

Jerry...
There is also a "single tool" Vectric postP that I posted on the Centroid Acorn Support Forum that was designed with reduced features that match what guys coming from ShopBot are used to.

[ger21]

Now I have to find the post processor for aspire 8.5 on a windows 11 machine.

In Aspire, under the File menu, select Open Application Data folder. It should be in there.