Shark 510, VCarve Pro
Trying to carve a dowel oriented on the Y axis to gain more length. To wrap around X, not sure which available post processors to use. Suggestions?
Post Processor to wrap X with Y orientation
- Rcnewcomb
- Vectric Archimage
- Posts: 5927
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Post Processor to wrap X with Y orientation
See this thread
viewtopic.php?p=258815#p258815
viewtopic.php?p=258815#p258815
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop