I am new to this forum. Hello everyone. I am tring to design a project on 3/4 board. how do I adjust the depth of the carve region with 3d figure and text? If I put the project on 1.5 thick board the bottom of the region is about 3/4 inch deep and the text is to tall. I would like to carve this on 3/4 inch board but not sure how to do it. If I leave on 1 1/2 board I am not sure how make the text not a tall. is there some one that help. I am a real newby.
Thanks for any help
Tom W.
adjusting the depth ofa carve regoin
Moderator: Todd Bailey
- watsonswords
- Posts: 23
- Joined: Tue Jul 09, 2013 5:01 am
- Model of CNC Machine: PDJ Pilot Pro
- Location: Bonney Lake, WA USA
- Contact:
adjusting the depth ofa carve regoin
Tom Watson www.signsinwood.com
-
- Vectric Wizard
- Posts: 858
- Joined: Wed Aug 16, 2006 7:34 pm
- Model of CNC Machine: shopbot 48x48 upgraded prt
- Location: Monessen, Pa
- Contact:
Re: adjusting the depth ofa carve regoin
I believe that when the setup page is up you can adjust the z depth.
Bob
Bob
- sawmiller
- Vectric Wizard
- Posts: 531
- Joined: Sat May 03, 2008 8:34 pm
- Model of CNC Machine: joe's rack and pinion hybrid
- Location: camden,tn
Re: adjusting the depth ofa carve regoin
Which software package are you using?
In aspire you can adjust the depth of the model under the modeling tab
In 3d cut I think its when you import the model
In aspire you can adjust the depth of the model under the modeling tab
In 3d cut I think its when you import the model
woodmizer sawmill and joe's hybrid cnc, a good combination
In the heart of Tn
In the heart of Tn