Another Raccoon

Discussions and examples relating to the Design & Carve series for Aspire

Moderator: Todd Bailey

Post Reply
jhegel
Posts: 38
Joined: Wed Jan 14, 2009 5:02 pm
Location: Ronan, Mt

Another Raccoon

Post by jhegel »

This one was for fun.

My Brother-in-law is in a constant battle with the raccoons.

Last time I stayed there, I was awaken at 2:00am with shot gun blasts. I got up to check it out and there he was with his 2 million candle power spot light shooting the raccoons out of the trees.

It took me a while, but I finally got an idea.

John
Rickie Raccoon.JPG

LouF
Vectric Craftsman
Posts: 102
Joined: Tue Oct 18, 2011 1:31 am
Model of CNC Machine: FLA100-00
Location: Hemet,CA.

Re: Another Raccoon

Post by LouF »

Nice I like it great wording..


Lou
Lou

ecurb5
Posts: 34
Joined: Fri May 27, 2011 5:53 pm
Model of CNC Machine: CNCRouterParts.com CRP4896

Re: Another Raccoon

Post by ecurb5 »

This is an awesome piece of work. Kudos!

Question, what's with the circles around the area of the third line?

tonydude919
Vectric Wizard
Posts: 762
Joined: Sat Jan 09, 2010 7:28 am
Model of CNC Machine: cnc mako shark ext bed with HD 5 gantry
Location: Buffalo,NY

Re: Another Raccoon

Post by tonydude919 »

Nice plaque. I have problems with ground hogs in my backyard.

Tony

jhegel
Posts: 38
Joined: Wed Jan 14, 2009 5:02 pm
Location: Ronan, Mt

Re: Another Raccoon

Post by jhegel »

ecurb5 wrote:This is an awesome piece of work. Kudos!

Question, what's with the circles around the area of the third line?

Thanks for the comments.

The circles are what happens when you do not chuck up a flat end mill to cut your texture toolpath. The endmill I used was slightly concave on the end.

John

Post Reply