Not sure on how to ask this.
I am running Aspire 11 and on a Shark system. I want to cut a couple of the "Magnolia" pieces from the D&M "plant and fruits". I created a new project (8" x 9") amd then imported the Manolia from the D&M site. How do I get the toolpaths? I thought the tool paths would come over with the down.load.
this is the first one of these types of projects for me. :
D&M item and paths
Moderator: Todd Bailey
- Todd Bailey
- Vectric Staff
- Posts: 625
- Joined: Mon Nov 24, 2014 8:40 pm
- Model of CNC Machine: CraftCNC
- Contact:
Re: D&M item and paths
Hello DET1242...
Thanks for the question... and welcome to your first 3D project.
This video might help... https://www.vectric.com/support/tutoria ... ower-model
Once you have a look through that add any questions to this post and we can give you a hand.
Thanks for the question... and welcome to your first 3D project.
This video might help... https://www.vectric.com/support/tutoria ... ower-model
Once you have a look through that add any questions to this post and we can give you a hand.
------------------------------------
Todd Bailey | Design and Make
DesignAndMake.com
Todd Bailey | Design and Make
DesignAndMake.com
Re: D&M item and paths
Thank You, for your response.
the project came out nice with the exception of the profile. I must not have tightened the bit down enough so it went a little wild. New piece of wood will fix that tomorrow.
thanks again for your support.
the project came out nice with the exception of the profile. I must not have tightened the bit down enough so it went a little wild. New piece of wood will fix that tomorrow.
thanks again for your support.
- Todd Bailey
- Vectric Staff
- Posts: 625
- Joined: Mon Nov 24, 2014 8:40 pm
- Model of CNC Machine: CraftCNC
- Contact:
Re: D&M item and paths
Hey DET1242...
Excellent... and good to hear. Keep safe and make sure that cutter is secure in your machine... yikes... but we have all done the same thing in the past...
Be safe!
Excellent... and good to hear. Keep safe and make sure that cutter is secure in your machine... yikes... but we have all done the same thing in the past...
Be safe!
------------------------------------
Todd Bailey | Design and Make
DesignAndMake.com
Todd Bailey | Design and Make
DesignAndMake.com