Virtual Zero Issue
- scotttarnor
- Vectric Wizard
- Posts: 944
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI
Re: Virtual Zero Issue
Sharkcutup, I did this with the pendant, I don't have the time right now, but I will try the Ready2control version to see if it is different.
Scott T
@scottscnc
@scottscnc
- scotttarnor
- Vectric Wizard
- Posts: 944
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI
Re: Virtual Zero Issue
I hooked up the laptop today and tried to duplicate the OP's issue, I could not duplicate it on the Ready2control software. Sharkcutup, you are correct on the Ready2control software. It does not care if X,Y datum position is set to center or bottom left, Virtual Zero still works were with the pendant it must be set to center.
Scott T
@scottscnc
@scottscnc