Virtual Zero Issue

User avatar
scotttarnor
Vectric Wizard
Posts: 941
Joined: Fri Aug 30, 2019 11:40 pm
Model of CNC Machine: Piranha XL , Shark HD520
Location: La Crosse WI

Re: Virtual Zero Issue

Post by scotttarnor »

Sharkcutup, I did this with the pendant, I don't have the time right now, but I will try the Ready2control version to see if it is different.
Scott T

@scottscnc

User avatar
scotttarnor
Vectric Wizard
Posts: 941
Joined: Fri Aug 30, 2019 11:40 pm
Model of CNC Machine: Piranha XL , Shark HD520
Location: La Crosse WI

Re: Virtual Zero Issue

Post by scotttarnor »

I hooked up the laptop today and tried to duplicate the OP's issue, I could not duplicate it on the Ready2control software. Sharkcutup, you are correct on the Ready2control software. It does not care if X,Y datum position is set to center or bottom left, Virtual Zero still works were with the pendant it must be set to center.
Scott T

@scottscnc

Post Reply