Updated my Software-Spindle will not engage
-
- Posts: 1
- Joined: Sat Jun 19, 2021 6:37 pm
- Model of CNC Machine: Shark HD520
- Location: Rock Hill, South Carolina
- Contact:
Updated my Software-Spindle will not engage
I just updated my controller and pendant software. (I run VCarvePro 11). When I run my Shark 520 everything seems to be working fine: The inverter is showing all blinking 0's; the LED's are reading steady green, blinking green, off, off, steady green; the pump is pumping; and the program is running properly; BUT the SPINDLE ISN'T SPINNING. I am flummoxed. I am not sure how to resolve this issue. The machine was running fine before I did the software update, so I figure that the problem must be related to the new programming, but I am not technically savvy and don't know where to begin to troubleshoot this sort of thing. Anybody out there able to help? Thanks in advance.
- Leo
- Vectric Wizard
- Posts: 4092
- Joined: Sat Jul 14, 2007 3:02 am
- Model of CNC Machine: 1300 x 1300 x 254 Chinese Made
- Location: East Freetown, Ma.
- Contact:
Re: Updated my Software-Spindle will not engage
In the new upgrade - did you migrate
Is the post processor the same as in the previous version before the upgrade?
Is the post processor the same as in the previous version before the upgrade?
Imagine the Possibilities of a Creative mind, combined with the functionality of CNC
- scotttarnor
- Vectric Wizard
- Posts: 945
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI
Re: Updated my Software-Spindle will not engage
"I just updated my controller and pendant software." this sounds like a question for Nextwave support if it was a controller and pendant upgrade and not a Vectric software upgrade.
support@nextwavecnc.com or call us at 419-318-4822 9AM-5PM EST Mon-Fri.
I am also curious to what software you updated both units to, I do not see any new software on their website?
support@nextwavecnc.com or call us at 419-318-4822 9AM-5PM EST Mon-Fri.
I am also curious to what software you updated both units to, I do not see any new software on their website?
Scott T
@scottscnc
@scottscnc
- scotttarnor
- Vectric Wizard
- Posts: 945
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI