Delayed response when issuing movement commands

Post Reply
jah364
Posts: 6
Joined: Fri Sep 26, 2014 11:08 pm
Model of CNC Machine: Camaster

Delayed response when issuing movement commands

Post by jah364 »

Hello,

I am currently experiencing an issue where upon pushing a movement command (x,y, or z) there is a delay of a second or two before it starts to move. It will stop upon releasing the key immediately without delay. On the monitor when I press the command to move, it shows the key being depressed instantly, so it seems it isnt a delay from the input of my keyboard. Has anyone experienced this problem before and if so, what did you do to remedy this?

Thanks,

James

User avatar
Rcnewcomb
Vectric Wizard
Posts: 3961
Joined: Fri Nov 04, 2005 5:54 am
Model of CNC Machine: GCnC/WinCNC
Location: San Jose, California, USA
Contact:

Re: Delayed response when issuing movement commands

Post by Rcnewcomb »

It may be a driver problem. Check for updates for your graphics card.
- Randall Newcomb
10 fingers in, 10 fingers out
another good day in the shop

jah364
Posts: 6
Joined: Fri Sep 26, 2014 11:08 pm
Model of CNC Machine: Camaster

Re: Delayed response when issuing movement commands

Post by jah364 »

I appreciate the response, it actually seems to be a networking issue. Upon disconnecting the ethernet cable the response time became immediate again.

Post Reply