Problems, transferring program to IS200

Post Reply
Posts: 3
Joined: Thu Jan 19, 2012 8:41 am
Model of CNC Machine: Gravograph IS200

Problems, transferring program to IS200

Post by madco »


I have a question.
Since a while i have a gravograph is200 machine.
At first i was working with gravostyle '98 i had no problems at all. but it was a very lite software.

So now i have vcarve pro 6.0, but i have a little problem while transferring.
I installed the right output device, it also transfers something to the machine.
But half-past the transfer, the machines display's "value too large"
Is this a known issue which i need to do some settings?
I really have no idea what this could cause.

With kind regards.

(p.s. i an from the netherlands, maybe that's easier for some people. in dutch the warning is "waarde te groot")

Post Reply