Mach 2 Depth Problem

Post Reply
customcnc
Posts: 45
Joined: Wed Aug 18, 2010 3:14 am

Mach 2 Depth Problem

Post by customcnc »

I am using Mach 2 and all of a sudden my z axis is plunging into the material and cutting at a greater depth than what is set. Could someone please help me on this? if it would be easier to explain by phone let me know. Thanks

kilrabit
Vectric Wizard
Posts: 487
Joined: Thu Feb 26, 2009 4:04 am
Location: Uvalde Texas

Re: Mach 2 Depth Problem

Post by kilrabit »

Need a little more information, are you using servos, or steppers? What type of machine?, this would be a start, and narrow things down a bit.




Roy

Post Reply