ncpodgcomilper message

Post Reply
Posts: 1
Joined: Wed Feb 23, 2011 4:22 pm

ncpodgcomilper message

Post by reeddave »

I have a CNC Shark and use V Carve Pro. Recently I have been getting an error message that states something about "ncpodgcompiler.exe has encountered a problem and must close..." when I try to load the g-code. Any idea how to fix this?

Vectric Craftsman
Posts: 204
Joined: Thu Jan 08, 2009 4:35 pm
Model of CNC Machine: Homebuilt 3'x5'x6"
Location: Willowick, Ohio USA

Re: ncpodgcomilper message

Post by Woodbutcher-59 »


I don't have a Shark, but I have read about a lot of weird things happening because of a bad/corrupted SD Card.

Try another card and see what happens.

Good luck with it !

Aspire 8
Mach 3

" I'm tryin to think but nothin happens " - Curly Howard

Post Reply