Access violation

Post Reply
Posts: 12
Joined: Sat Jan 29, 2011 8:18 pm

Access violation

Post by Bmw »

What does( access violation at address 00509632 in module Cnc shark basic panel exe read of address 015510e4) mean? It came up after running the flat part of a toolpath and would not go away until a reboot of the computer then the next tool path did not come out right. And tool paths have not been coming out the same as the preview.

Vectric Wizard
Posts: 969
Joined: Tue Mar 20, 2007 6:29 am
Model of CNC Machine: ShopBot prt with 4g upgrade
Location: Visalia, Ca

Re: Access violation

Post by calgrdnr »

Hmm if it was me I would ask the people at Shark not the people at Vectric ....
Hello and welcome to the forum, If you have a lot of trouble getting your Shark up and running, there is a Shark forum at and is often visited by the manufacturer of the Shark and Rockler. This is the best place to start. ...

Vectric Craftsman
Posts: 204
Joined: Thu Jan 08, 2009 4:35 pm
Model of CNC Machine: Homebuilt 3'x5'x6"
Location: Willowick, Ohio USA

Re: Access violation

Post by Woodbutcher-59 »

Try swapping the SD card for another....

Aspire 8
Mach 3

" I'm tryin to think but nothin happens " - Curly Howard

Post Reply