Access violation

Post Reply
Bmw
Posts: 12
Joined: Sat Jan 29, 2011 8:18 pm

Access violation

Post by Bmw »

What does( access violation at address 00509632 in module Cnc shark basic panel exe read of address 015510e4) mean? It came up after running the flat part of a toolpath and would not go away until a reboot of the computer then the next tool path did not come out right. And tool paths have not been coming out the same as the preview.

calgrdnr
Vectric Wizard
Posts: 969
Joined: Tue Mar 20, 2007 6:29 am
Model of CNC Machine: ShopBot prt with 4g upgrade
Location: Visalia, Ca

Re: Access violation

Post by calgrdnr »

Hmm if it was me I would ask the people at Shark not the people at Vectric ....
Hello and welcome to the forum, If you have a lot of trouble getting your Shark up and running, there is a Shark forum at http://www.cncsharktalk.com and is often visited by the manufacturer of the Shark and Rockler. This is the best place to start. ...

Woodbutcher-59
Vectric Craftsman
Posts: 204
Joined: Thu Jan 08, 2009 4:35 pm
Model of CNC Machine: Homebuilt 3'x5'x6"
Location: Willowick, Ohio USA

Re: Access violation

Post by Woodbutcher-59 »

Try swapping the SD card for another....

Jeff
Aspire 8
Mach 3

" I'm tryin to think but nothin happens " - Curly Howard

Post Reply