Gcode sender

Post Reply
cusoak
Vectric Wizard
Posts: 384
Joined: Mon Nov 06, 2017 1:57 pm
Model of CNC Machine: Shapeoko 3D XXL

Gcode sender

Post by cusoak »

I had to get a new computer. I need help with getting Carbide motion set up as the prog to open and run the shapeoko gcode from the list of post processors in vcarvepro.
I hope that made sense.
Jeff

User avatar
jfederer
Vectric Apprentice
Posts: 77
Joined: Tue Nov 27, 2018 1:09 am
Model of CNC Machine: CanCam D23M
Location: Horton Township Ontario Canada
Contact:

Re: Gcode sender

Post by jfederer »

I've used this one: https://winder.github.io/ugs_website/ Use GRBL (inch)(*.gcode) or GRBL (mm) (*.gcode) as the Post Processor.
Joe Federer

www.fabrikisto.com
www.federer.ca

Post Reply