i started out with a piranha FX CNC and V carve 9 about 4 years ago, then eventually I upgraded to aspire 11. in the last 6 months i have purchased 2 larger CNC's a Mega V 35" x 35" and a Mega V 50" x 50", both by Millwright CNC. my issues are as follows
1) even on 1/8" Baltic birch the machine will jump off the homing settings approximately 2" after a first project is started.
2) i keep losing my tool data base and must re do them for each project,
3) if using thicker wood than the Baltic Birch the machines will do a rough in pass completely then after doing a bit change to do the first
of 4 finish passes with a 1/8" ball nose bit it will either go to the opposite end from start point, and start running the project in revers of
what I have the rough in done in.
4) V-transfer will only do a homing cycle and shut down the machine, UGS (supplied by manufacturer of machine) preforms the above
things.
How do I correct these issues? these issues have caused me to ruin approximately 30 board feet of prime Red Oak and i do not wish to ruin any more.
malfunctioning CNC
-
- Posts: 5
- Joined: Fri Aug 03, 2018 8:54 pm
- Model of CNC Machine: pirahna fx, Millwright mega V XXL
- Leo
- Vectric Wizard
- Posts: 4091
- Joined: Sat Jul 14, 2007 3:02 am
- Model of CNC Machine: 1300 x 1300 x 254 Chinese Made
- Location: East Freetown, Ma.
- Contact:
Re: malfunctioning CNC
Have you contacted Millright?
Have you asked questions on the Millright forum
www.millrightcnc.proboards.com
Have you asked questions on the Millright forum
www.millrightcnc.proboards.com
Imagine the Possibilities of a Creative mind, combined with the functionality of CNC
-
- Posts: 5
- Joined: Fri Aug 03, 2018 8:54 pm
- Model of CNC Machine: pirahna fx, Millwright mega V XXL
Re: malfunctioning CNC
i have sent them a message requesting help last Wednesday no one has returned any instrucyions as to how to solve this issue to me