Richauto A11 DSP controller problem

Post Reply
MIKEKALIST
Posts: 1
Joined: Mon May 06, 2019 6:08 pm
Model of CNC Machine: CR1212

Richauto A11 DSP controller problem

Post by MIKEKALIST »

Hello all. I had to get a new controller and i do not know the old settings.
How can i adjust the Pulse per mm to be exact. I use V carve Pro and when i draw our a 100mm square i have it cutting a 100 mm square,

When i use a dwg file to make all my tool paths it is out by 20 or so mm

Not sure what or where to even start looking.

Post Reply