Wire came loose from CNC Shark Pro contro box
Wire came loose from CNC Shark Pro contro box
Hello all, I found the wire off from the control box to the "other smaller box". (don't know what it is called). Machine and table was recently moved and wire must have come lose then. I don't know where to connect the wire back to the smaller box. It has connections on the side that say "V- V- V+. Does it go on one of these? I have an older Shark Pro. I think the first model shark pro. approx. 8 yrs old.
Re: Wire came loose from CNC Shark Pro contro box
PS I did see the "smaller box" is the power supply.
-
- Vectric Wizard
- Posts: 520
- Joined: Sun May 03, 2015 12:25 pm
- Model of CNC Machine: Axiom AR8
- Location: Savannah, GA
Re: Wire came loose from CNC Shark Pro contro box
Sorry, I sold my old Shark Pro and don't have any of it to look at. Did you post this on the Shark Forum - https://www.cncsharktalk.com/viewforum.php?f=2.
- scubanimal
- Vectric Craftsman
- Posts: 152
- Joined: Tue Mar 12, 2013 9:16 pm
- Model of CNC Machine: Stinger1 24, Shark HD2 Pro, Aspire,
- Location: San Diego
Re: Wire came loose from CNC Shark Pro contro box
Bonds,
If you're still having a problem, post a pic and I'll look on my shark and see where it goes.
V/R,
Ian
If you're still having a problem, post a pic and I'll look on my shark and see where it goes.
V/R,
Ian
-
- Vectric Craftsman
- Posts: 110
- Joined: Thu Jan 08, 2009 6:24 am
- Model of CNC Machine: CAMaster Stinger SR-23
- Location: Orange, CA
Re: Wire came loose from CNC Shark Pro contro box
On my Shark pro.....
I have the older Shark pro that I no longer use. The controller wires to the power supply on my unit = RED and it goes to +V the BLACK goes to -V on my unit.
Dan
I have the older Shark pro that I no longer use. The controller wires to the power supply on my unit = RED and it goes to +V the BLACK goes to -V on my unit.
Dan