Laguna IQ hhc problem

Post Reply
PATRICKCUES
Posts: 16
Joined: Sun Mar 11, 2018 3:35 am
Model of CNC Machine: LAGUNA IQ

Laguna IQ hhc problem

Post by PATRICKCUES »

I have a Laguna iq.
I'm getting power to my HHC but nothing else. Like it wont boot up. Just a blank screen. anyone have any suggestions??
I checked all my fuses and they are all good . Pin connector is good with no damage ..

litzluth
Vectric Craftsman
Posts: 103
Joined: Fri May 09, 2014 1:37 pm
Model of CNC Machine: Laguna IQ

Re: Laguna IQ hhc problem

Post by litzluth »

Did you check to see if the emergency stop button accidentally got pressed in? Try twisting clockwise to see if it pops out.

PATRICKCUES
Posts: 16
Joined: Sun Mar 11, 2018 3:35 am
Model of CNC Machine: LAGUNA IQ

Re: Laguna IQ hhc problem

Post by PATRICKCUES »

Yes I have checked it. I pushed it in and turned it out several times . I've rebooted it several times. Unplugged it for a hour and turned it back on. Still same problem

litzluth
Vectric Craftsman
Posts: 103
Joined: Fri May 09, 2014 1:37 pm
Model of CNC Machine: Laguna IQ

Re: Laguna IQ hhc problem

Post by litzluth »

And then pressed (again) the green start button?

Post Reply