Lead screw choice dilemma

Post Reply
cwolfs69
Posts: 4
Joined: Thu Aug 18, 2016 7:51 pm
Model of CNC Machine: cnc3040 router

Lead screw choice dilemma

Post by cwolfs69 »

i am replacing the lead screws on my small cnc router. the old screws are 10mm-2mm, 2 lead acme screws, (0.160"/ rev±) and work okay. i am replacing with 1/2-10 acme screws and was debating whether to use single start (0.100"/rev) or 2 start (0.200"/rev) threads. my first thought was single so the it would require less torque to move the axis around the table. but then i thought the stepper motor would have to rotate twice as fast and that can cause problems as well. of course the 2 start would have the closest pitch to the original. does anyone have any thoughts about my choices.
i am also upgrading the stepper motors to higher torque as well, going to 296oz/in vs whatever those that came on my chinese router are, very weak

any thoughts or advice would be helpful. i have been unable to find whether its better with fast travel or less torque when installing lead screws on a cnc.

calgrdnr
Vectric Wizard
Posts: 969
Joined: Tue Mar 20, 2007 6:29 am
Model of CNC Machine: ShopBot prt with 4g upgrade
Location: Visalia, Ca

Re: LEAD SCREW CHOICE DELEMA

Post by calgrdnr »

when I built my Joes2006 in 2007 I used 1/2- 2 start went to a 1/2- 5 start what a difference faster and smoother .
CNCzone.com would be the place I would look for answers to your question :)

http://www.cnczone.com/forums/woodworki ... e90ab9a756

User avatar
Mogal
Vectric Craftsman
Posts: 203
Joined: Wed Oct 13, 2010 5:28 pm
Model of CNC Machine: DIY CNC
Location: Victoria, BC
Contact:

Re: Lead screw choice dilemma

Post by Mogal »

Hello,

Thought I'd chime in as I have the 1/2-10 dual start acme threads on my machine.
For a quick reference, I get a max of 160ipm on my machine which makes for a resolution of nearly 0.0002"
Problem with my machine though, is that I have a bad choice of steppers with a high impedance of 6.8mH (36v)
This makes the motors fairly slow (max of about 285rpm)
With better motors, maybe 300ipm would be doable. (500rpm steppers)
My machine is about 24"x30" and even at my 160ipm isn't too bad for this size of machine.

Chris

ger21
Vectric Wizard
Posts: 1526
Joined: Sun Sep 16, 2007 2:59 pm
Model of CNC Machine: Custom DIY
Location: Shelby Township, MI, USA
Contact:

Re: Lead screw choice dilemma

Post by ger21 »

160ipm with a 1/2-10 2 start screw is 800rpm, not 285rpm.

At 285rpm, even a 5 start screw would only give you 142ipm.
Gerry - http://www.thecncwoodworker.com

Post Reply