Notes on the Zank VCarve inlay process.

Post by **FixitMike** » Tue Dec 10, 2019 11:17 pm

I've written up some of what I know about the Zank inlay. I hope it will be helpful. Your comments are welcome.

Notes on the Zank VCarve Inlay.pdf: (263 KiB) Downloaded 719 times

Post by **mtylerfl** » Wed Dec 11, 2019 1:44 am

Thank you for doing that, Mike.

Post by **rtibbs** » Wed Dec 11, 2019 12:50 pm

+1
Thanks for taking the time to write this up Mike.
Always nice to have it to refer to when needed

Ron

Post by **newmexico** » Wed Dec 11, 2019 2:20 pm

Wow!
Very good info. Practical and to-the-point.
Greatly appreciated.

Post by **jay pieper** » Wed Dec 11, 2019 4:16 pm

Thanks Mike for taking the time to put notes together on this subject.
I do a lot of inlay projects, some really good, some not so much.
I have got these notes downloaded for easy access to refer to when designing
a project. I have already caught a few things that I can use on my next inlay.
It is always nice to pick up tips from experienced operators. THANK YOU!!!

Post by **litzluth** » Wed Dec 11, 2019 4:28 pm

Thank you for this very helpful piece.
Makes the process very straightforward.

Vectric Customer

Notes on the Zank VCarve inlay process.

Notes on the Zank VCarve inlay process.

Re: Notes on the Zank VCarve inlay process.

Re: Notes on the Zank VCarve inlay process.

Re: Notes on the Zank VCarve inlay process.

Re: Notes on the Zank VCarve inlay process.

Re: Notes on the Zank VCarve inlay process.