Cutting too deep!

This forum is for users to post tips and tricks they have found useful while working with VCarve Pro
Vectric Apprentice
Posts: 2
Joined: Mon Dec 28, 2015 11:22 pm
Model of CNC Machine: Shark Pro

Re: Cutting too deep!

Post by ngh »

Just a wild thought.

We sold off our 'Shark' CNC because we could not get around it cutting too deep for end mill cuts, even shallow depth cuts.

What happened was the bit dug into the work piece with enough pressure to pull itself further into the work piece.

After research into CNC designs and specifications, we feel this was a design fault of our particular 'Shark' model it was a few years old when we purchased it second hand.
OK if you only wanted to carve but definitely not for cutting with end mills.


Post Reply