Page 1 of 1

Bar and vanities

Posted: Sun Dec 08, 2024 1:17 am
by JeffZ
Here is a bar and some vanities I made for a local event center that just opened.
I drew the bar in my cabinet software, imported it into aspire, and used aspire to cut the majority of it.
The logo is an epoxy inlay, made with aspire.
The vanities were also drawn up and cut using aspire.
The drawer boxes in the vanities were made with the easy box maker gadget that jimandi5000 and sharkcutup are working on.

Re: Bar and vanities

Posted: Sun Dec 08, 2024 5:42 am
by sharkcutup
Very Nice Job!!!

Sharkcutup

Re: Bar and vanities

Posted: Tue Dec 10, 2024 8:19 pm
by FabLab Wageningen
Looks really good - and practical, too.

Are the vanities double-sided ?

Marcel.

Re: Bar and vanities

Posted: Tue Dec 10, 2024 11:40 pm
by JeffZ
Thanks guys.
Yep, the vanities are double sided.
I'm pretty sure I could have done this in vcarve pro too, I didn't touch the modeling tab while I was doing it. Mostly profile cuts, plus I did a vcarve for the logo inlay.

Re: Bar and vanities

Posted: Wed Dec 11, 2024 7:39 am
by Jimcad
Yes. Very nice.