Concrete Mermaid

This is the place to post images of work produced using Aspire
Post Reply
garylmast
Vectric Wizard
Posts: 1580
Joined: Fri Oct 23, 2009 4:03 pm
Location: Sandy, Utah

Concrete Mermaid

Post by garylmast »

From the opposite end of the room where I put the Concrete Angel, (viewtopic.php?f=29&t=37268 ) I had another big pot I needed something to put in, so I decided to do a Mermaid out of Styrofoam then apply a cement texture. Painting it white didn't look good, so I decided to add a few highlighted colors. I first applied mortar, spreading it by hand, then a concrete patching material that made it a little smoother and gave it pretty good strength. Almost every slice was a double-side cut done in Aspire.

Gary
Attachments
Mermaid__1818.jpg
Mermaid__1817.jpg
Mermaid__1819.jpg
Mermaid_1816.jpg

garylmast
Vectric Wizard
Posts: 1580
Joined: Fri Oct 23, 2009 4:03 pm
Location: Sandy, Utah

Re: Concrete Mermaid

Post by garylmast »

I decided to make it so it wasn't X-rated.

Gary
Attachments
IMG_1820.JPG

Post Reply