Here's something you can make in about 5 minutes to give some piece of mind. Seen a lot of these for sale made out of brass, from a lot of different places. All the ones I've seen were for one finger, I made this so you could use 2 or three fingers. The black ones I cut from HDPE and the clear from polycarbonate, both 1/4" thick. Works well to open close a door without having to touch the handle.
If you would like an STL of this, PM me and I'll email it to you.
Thanks for looking.
Door opener
-
- Vectric Wizard
- Posts: 594
- Joined: Wed Mar 27, 2013 4:16 pm
- Model of CNC Machine: CNC Shark Pro Plus
- Contact:
Door opener
BillK
https://www.facebook.com/CarvingsByKurtz
https://www.facebook.com/CarvingsByKurtz
-
- Vectric Wizard
- Posts: 594
- Joined: Wed Mar 27, 2013 4:16 pm
- Model of CNC Machine: CNC Shark Pro Plus
- Contact:
Re: Door opener
I got a few requests for the stl on this. So if your finally venturing out now you might one for family and friends.
BillK
https://www.facebook.com/CarvingsByKurtz
https://www.facebook.com/CarvingsByKurtz