Door opener

[BillK]

Here's something you can make in about 5 minutes to give some piece of mind. Seen a lot of these for sale made out of brass, from a lot of different places. All the ones I've seen were for one finger, I made this so you could use 2 or three fingers. The black ones I cut from HDPE and the clear from polycarbonate, both 1/4" thick. Works well to open close a door without having to touch the handle.

If you would like an STL of this, PM me and I'll email it to you.

Thanks for looking.

[BillK]

I got a few requests for the stl on this. So if your finally venturing out now you might one for family and friends.