Door opener

This is the place to post images of work produced using Aspire
Post Reply
BillK
Vectric Wizard
Posts: 415
Joined: Wed Mar 27, 2013 4:16 pm
Model of CNC Machine: CNC Shark Pro Plus
Contact:

Door opener

Post by BillK »

Here's something you can make in about 5 minutes to give some piece of mind. Seen a lot of these for sale made out of brass, from a lot of different places. All the ones I've seen were for one finger, I made this so you could use 2 or three fingers. The black ones I cut from HDPE and the clear from polycarbonate, both 1/4" thick. Works well to open close a door without having to touch the handle.

If you would like an STL of this, PM me and I'll email it to you.

Thanks for looking.
key.jpg
BillK
https://www.facebook.com/CarvingsByKurtz

BillK
Vectric Wizard
Posts: 415
Joined: Wed Mar 27, 2013 4:16 pm
Model of CNC Machine: CNC Shark Pro Plus
Contact:

Re: Door opener

Post by BillK »

I got a few requests for the stl on this. So if your finally venturing out now you might one for family and friends.
BillK
https://www.facebook.com/CarvingsByKurtz

Post Reply