Twisted Circles

[rlp17820]

I came across a topic (May 2015) that inspired me to create and machine a twisted square, pentagon and hexagon. The twisted circles were created in Blender and then imported to Aspire as a two-sided job.

The boundary offset of the finish toolpaths and the limit planes on both sides were adjusted to minimize or eliminate any undercut areas. This left me with very little hand sanding as a result.

Each twisted circle is approximately 7/8 inch thick.

The topic that inspired me was http://forum.vectric.com/viewtopic.php? ... e+triangle

[CrowsWW]

Very Nice. I love these things. Just not talented enough yet! to make them.

[scottp55]

Those look Great!
Look like they'd be fun to handle too!
Congrats.
scott

[rlp17820]

Thanks for the compliments.

Scott, yes they are nice to handle and simpler than a fidget spinner.

[eph210]

Those came out very well.

Euan

[Creation in Wood]

I see you are also in Monument, Colorado
Great idea on the Twisted Circles