2 Owls on a log

This is the place to post images of work produced using Aspire
Post Reply
mark-s
Vectric Apprentice
Posts: 210
Joined: Sat Feb 03, 2018 2:03 am
Model of CNC Machine: diy 4 X 4 CNC Router
Location: So. Cal.

2 Owls on a log

Post by mark-s »

2 Owls on a log, 3 inch tall X 1-3/4 inch wide.
Maple,from an old cabinet door, clear coat.
1 mm TBN used on the model, 3.175 end mill, profile cut.
mark-s
CNC 2 OWLS ON A LOG 7.jpg

BillK
Vectric Wizard
Posts: 393
Joined: Wed Mar 27, 2013 4:16 pm
Model of CNC Machine: CNC Shark Pro Plus
Contact:

Re: 2 Owls on a log

Post by BillK »

Nice work Mark. Always like to see a curved backgroud! The world is not flat.
BillK
https://www.facebook.com/CarvingsByKurtz

Post Reply