Great Horned Owl

This is the place to post images of work produced using Aspire
Post Reply
mark-s
Vectric Apprentice
Posts: 208
Joined: Sat Feb 03, 2018 2:03 am
Model of CNC Machine: diy 4 X 4 CNC Router
Location: So. Cal.

Great Horned Owl

Post by mark-s »

Great Horned Owl.
3 inch tall X 1- 3/16 inch wide.
Maple, clear coat.
Maple carves so nice and clean.
mark-s
CNC GREAT HORNED OWL 8.jpg

User avatar
mtylerfl
Vectric Wizard
Posts: 4671
Joined: Thu Jan 29, 2009 3:54 am
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
Location: Brunswick, GA
Contact:

Re: Great Horned Owl

Post by mtylerfl »

I Like it!
Michael Tyler

carvebuddy.com

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC

User avatar
scottp55
Vectric Wizard
Posts: 3690
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP10
Location: Kennebunkport, Maine, US

Re: Great Horned Owl

Post by scottp55 »

NICE clean cut Tiny piece Mark!! :)
Gotta look for that model:)
scott
scott

User avatar
Creation in Wood
Vectric Wizard
Posts: 521
Joined: Thu May 28, 2015 8:58 pm
Model of CNC Machine: Legacy Maverick 2020 4x8 CNC
Location: Monument, Colorado USA

Re: Great Horned Owl

Post by Creation in Wood »

I like the Great Horned Owl.
Where did you get the model? I would like to cut a bigger one.
Thank You
Doug

bravesoul
Vectric Apprentice
Posts: 198
Joined: Thu Sep 11, 2014 8:53 pm
Model of CNC Machine: ShopBot PRT ALPHA 48"x96"
Location: Cleveland, TN
Contact:

Re: Great Horned Owl

Post by bravesoul »

I found some similar STL's (I think) here: https://www.yeggi.com/q/great+horned+owl/

User avatar
TReischl
Vectric Wizard
Posts: 3559
Joined: Thu Jan 18, 2007 6:04 pm
Model of CNC Machine: 8020 Build 48X36X10 RP 2010 Screenset
Location: Leland NC

Re: Great Horned Owl

Post by TReischl »

bravesoul wrote:I found some similar STL's (I think) here: https://www.yeggi.com/q/great+horned+owl/
Gotta be careful shopping STL files. A lot of them are full in the round 3D. Those are difficult to work with usually. Well, that has been my experience anyhow.
"If you see a good fight, get in it." Dr. Vernon Jones

Post Reply