Desk top clock holder

This is the place to post images of work produced using Aspire
Post Reply
Vectric Apprentice
Posts: 211
Joined: Sat Feb 03, 2018 2:03 am
Model of CNC Machine: diy 4 X 4 CNC Router
Location: So. Cal.

Desk top clock holder

Post by mark-s »

Got the clock from local swap meet for $1.00.
Have a stash of the 11 ply from a job years ago.
This is a test piece, 11 ply oak veneer.
Cheated on the layer look of the name,
engraved it then filled it with a darker wood filler.
Final one will be from solid oak with a base.

User avatar
Vectric Wizard
Posts: 3211
Joined: Tue Jan 06, 2015 4:04 pm
Model of CNC Machine: PDJ Pilot Pro

Re: Desk top clock holder

Post by highpockets »

Nice "test" piece Mark. Based on this I can't wait to see the final piece....
Maker of Chips

User avatar
Vectric Wizard
Posts: 3745
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP10
Location: Kennebunkport, Maine, US

Re: Desk top clock holder

Post by scottp55 »


Mark...Can you save pics a little larger?
Hard to see the Lion details:)

Oh...I remember thinking that would look nice with a little pocket "Niche" for the Lion in the bottom?
Be a PITA to sand, so I'd be really careful to make a clean pocket!
"Go not where the path may lead;
Go instead where there is no path, and leave a Trail"

Post Reply