Miniature green man plaque

This is the place to post images of work produced using Aspire
Post Reply
mark-s
Vectric Apprentice
Posts: 211
Joined: Sat Feb 03, 2018 2:03 am
Model of CNC Machine: diy 4 X 4 CNC Router
Location: So. Cal.

Miniature green man plaque

Post by mark-s »

Miniature green man plaque.
3.5 in tall X 3.125 in wide.
1/2 oak, .5 R ball nose bit,
Clear matte finish.
mark-s
Attachments
CNC GREEN MAN PLAQUE 5.jpg

User avatar
TReischl
Vectric Wizard
Posts: 3624
Joined: Thu Jan 18, 2007 6:04 pm
Model of CNC Machine: 8020 Build 48X36X10 RP 2010 Screenset
Location: Leland NC

Re: Miniature green man plaque

Post by TReischl »

Looks great!

Are you sure about:
mark-s wrote:.5 R ball nose bit,
?????

Evidently you have one of those really super dooper .5R ball nose bits that reaches right into tight spots! 8)
"If you see a good fight, get in it." Dr. Vernon Jones

User avatar
scottp55
Vectric Wizard
Posts: 3737
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP10
Location: Kennebunkport, Maine, US

Re: Miniature green man plaque

Post by scottp55 »

Mark is Metric Ted.
Probably one of these in .5mm R...like the .25mm R in picture.
9.2.17 CHINESE .25MM R TBN.jpg
scott
"Go not where the path may lead;
Go instead where there is no path, and leave a Trail"
RWE

User avatar
TReischl
Vectric Wizard
Posts: 3624
Joined: Thu Jan 18, 2007 6:04 pm
Model of CNC Machine: 8020 Build 48X36X10 RP 2010 Screenset
Location: Leland NC

Re: Miniature green man plaque

Post by TReischl »

scottp55 wrote:Mark is Metric Ted.
Probably one of these in .5mm R...like the .25mm R in picture.
9.2.17 CHINESE .25MM R TBN.jpg
scott
Oh yeah, Scott? It seems to me he is one of those Inch/Metric guys actually. Says it is so many inches wide, then that it is 1/2 something or other thick, then he springs a metric bit on a poor unsuspecting kid like me? Oh the horror of it all! I am heading off to my safe space now, hopefully no one has stolen MY crayons! :shock:
"If you see a good fight, get in it." Dr. Vernon Jones

User avatar
martin54
Vectric Wizard
Posts: 4944
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber System 48,Denford Triac Modified
Location: Crossgates, Scotland

Re: Miniature green man plaque

Post by martin54 »

You seem to be doing a few of these at the moment Mark :lol: :lol:

I am heading off to my safe space now, hopefully no one has stolen MY crayons! :shock:

Sorry Ted I borrowed them but you can have them back as they have now just put my white jacket on & I can't pick them up anymore :roll: :roll:

Post Reply