Party Snack Trays

This is the place to post images of work produced using Aspire
scalci
Posts: 9
Joined: Tue Jan 22, 2019 7:48 pm
Model of CNC Machine: Home Build Mach3

Re: Party Snack Trays

Post by scalci »

Very cool idea, and well made...

Rybuggy
Vectric Apprentice
Posts: 8
Joined: Sun Dec 03, 2017 12:23 am
Model of CNC Machine: Shark HD4
Location: Chagrin Falls, Ohio

Re: Party Snack Trays

Post by Rybuggy »

SB61 wrote:Rybuggy,
Nice job....what are the dimensions of the tray.
Thanks,
Sam
Thanks Sam,

the part it's self it about 9.375x 6.25. I used .625 thick stock, and carved the pocket .25 deep on each side, leaving a .125" thick center. it feels a little too thin, next time I make some I would make the pockets a little shallower, or stock a little thicker. as always, there is something to do to make it better next time

Post Reply