Page 1 of 1

Bass Kit body with carvings

Posted: Thu Aug 04, 2016 5:52 pm
by galerdude
Finally finished up this bass kit I'd had for a year and a half :roll: with some carvings. Main intent is to take it camping and such and not worry about dingin' it up. Fun project!
IMG_20160803_145252714-2.jpg
IMG_20160803_145417992-2.jpg

Re: Bass Kit body with carvings

Posted: Thu Aug 04, 2016 8:16 pm
by MTSO
cool mate love the carving on the back, how long did it take to carve?.

regards

Brian

Re: Bass Kit body with carvings

Posted: Thu Aug 04, 2016 9:25 pm
by galerdude
MTSO wrote:cool mate love the carving on the back, how long did it take to carve?.

regards

Brian
Thanks Brian!
I run stuff pretty slow so please take that into account;
1 - Approximately an hour (V-carve) clearing with .125" end mill @ 80 ipm; .1" deep.
2 - Almost 4 hours V-carving with 60 degree laser bit @ 60 ipm; .1" deep.

Thanks again for the comment!

Re: Bass Kit body with carvings

Posted: Tue Aug 16, 2016 1:40 pm
by cabnet636
Very Nice !

Re: Bass Kit body with carvings

Posted: Tue Aug 16, 2016 8:23 pm
by galerdude
cabnet636 wrote:Very Nice !
Thank You, very much, James!

Re: Bass Kit body with carvings

Posted: Tue Aug 30, 2016 2:38 am
by galerdude
Thank You Vectric!
I am very humbled and honored that you included this project in your newsletter!