Page 1 of 1

Before and After - Sign for Salvation Army

Posted: Fri Jun 13, 2014 7:55 pm
by customquint
Love getting before and after shots of projects.

The sign and posts with inlay for the locking cabinet where all done in Aspire.
BEFORE
BEFORE
After
After

Re: Before and After - Sign for Salvation Army

Posted: Fri Jun 13, 2014 8:21 pm
by zeeway
Gigantic improvement. Nice work.

Angie

Re: Before and After - Sign for Salvation Army

Posted: Fri Jun 13, 2014 9:57 pm
by CarveOne
That IS a nice improvement. Ya need to sneak back over there and paint that rusty pipe rail gloss black when they aren't looking and your work will shine even better. ;)

CarveOne

Re: Before and After - Sign for Salvation Army

Posted: Sat Jun 14, 2014 7:40 pm
by customquint
CarveOne wrote:That IS a nice improvement. Ya need to sneak back over there and paint that rusty pipe rail gloss black when they aren't looking and your work will shine even better. ;)

CarveOne
My client told me that they where planning on removing the old pipe railing.

If I would have had a torch with me I'd cut her off just below ground level for them.

Re: Before and After - Sign for Salvation Army

Posted: Sat Jun 14, 2014 8:22 pm
by 4DThinker
That railing no doubt was a solution to people "crossing" over the grass when turning the corner in front of the sign. Folks probably used to touch it or mess with the sign message when they did as well. You may re-introduce all sorts of unacceptable human behavior if you (they) remove the railing! :oops:

Re: Before and After - Sign for Salvation Army

Posted: Sat Jun 14, 2014 8:22 pm
by Leo
Could you use a metal cutting blade on a sawzall?