A cross for friends.

This is the place to post images of work produced using Aspire
Post Reply
Mike Kelly
Posts: 39
Joined: Tue Aug 08, 2006 9:55 pm
Model of CNC Machine: ShopBot
Location: Austin, TX

A cross for friends.

Post by Mike Kelly »

Here are some crosses I made for a friend. The larger one was Western Red Cedar and the smaller ones were Cherry. With a clear finish on them they were very similar in color. Up close you could see the grain structure, but from a few feet you couldn't tell. The Cedar was the largest board I had laying around from an old deck board 2 x 12. Turned out nice.
Attachments
Celtic Crosses
Celtic Crosses
Celtic Crosses
Celtic Crosses
ShopBot PRT Benchtop with 4G upgrade and PC router.
PartWorks
Aspire
PhotoVCarve

CarveOne
Vectric Wizard
Posts: 1381
Joined: Sun Nov 28, 2010 5:10 pm
Model of CNC Machine: Home built designs - 3'x4' and 5'x12'
Location: Eastern NC, USA
Contact:

Re: A cross for friends.

Post by CarveOne »

Those look great Mike! They are really nice.

CarveOne
CarveOne
http://www.carveonecncwoodcraft.com

User avatar
mikeacg
Vectric Wizard
Posts: 652
Joined: Sun Nov 02, 2008 10:53 pm
Model of CNC Machine: Camaster Stinger, Sidewinder, SB 4x4
Location: Newberry, MI
Contact:

Re: A cross for friends.

Post by mikeacg »

They look great Mike! Thanks for sharing!

Mike :D

Post Reply