Hello all! Been a while as my CNC machine has been down due to spindle repair...over $4,000. But since I've been back up & running I've got to carve out a couple pieces I've modeled in Aspire. Carved out of 15lb. HDU and treated with a primer then painted with Sculpt Nouveuo paints to add a metalic effect. I still have to clear coat it with a satin clear made by SN and I'm going to build a custom black walnut frame to go around the piece. I'm going to look for an art gallery on the higher-end to see if I can find a market for these. Anyone have any idea on where I should start on pricing? I know that question can be answered anywhere across the board!
Thanks!
Vic
PS - They are 4ft tall and around 1-1/2" thick
Fine Art...sort of! 2 pieces
-
- Vectric Craftsman
- Posts: 152
- Joined: Mon Dec 20, 2010 9:18 pm
- Model of CNC Machine: 5ft x 8ft 11"inch Z axis 24k-rpm
- Location: North Alabama
- Contact:
Fine Art...sort of! 2 pieces
http://www.rev-art.comKeep those in your life that charge your battery, not drain it.
-
- Vectric Wizard
- Posts: 586
- Joined: Sat Jan 08, 2011 12:29 pm
- Model of CNC Machine: Professional done home built.
- Location: SW Michigan
Re: Fine Art...sort of! 2 pieces
@ about $100 a sq ft,, you can see the value.
- mboydraska
- Vectric Craftsman
- Posts: 238
- Joined: Sun Jun 10, 2007 12:07 am
- Model of CNC Machine: 3 axis homebuilt
- Location: Iowa
- Contact:
-
- Vectric Craftsman
- Posts: 152
- Joined: Mon Dec 20, 2010 9:18 pm
- Model of CNC Machine: 5ft x 8ft 11"inch Z axis 24k-rpm
- Location: North Alabama
- Contact:
Re: Fine Art...sort of! 2 pieces
Thanks Mike! I'm just glad to be back up % running!
Vic
Vic
http://www.rev-art.comKeep those in your life that charge your battery, not drain it.