Bar and vanities

[JeffZ]

Here is a bar and some vanities I made for a local event center that just opened.
I drew the bar in my cabinet software, imported it into aspire, and used aspire to cut the majority of it.
The logo is an epoxy inlay, made with aspire.
The vanities were also drawn up and cut using aspire.
The drawer boxes in the vanities were made with the easy box maker gadget that jimandi5000 and sharkcutup are working on.

[sharkcutup]

Very Nice Job!!!

Sharkcutup

[FabLab Wageningen]

Looks really good - and practical, too.

Are the vanities double-sided ?

Marcel.

[JeffZ]

Thanks guys.
Yep, the vanities are double sided.
I'm pretty sure I could have done this in vcarve pro too, I didn't touch the modeling tab while I was doing it. Mostly profile cuts, plus I did a vcarve for the logo inlay.

[Jimcad]

Yes. Very nice.