Need some help!!!
Re: Need some help!!!
Joe did a great job on this but I'd like to see how it could be done only using Aspire.
- joecnc2006
- Vectric Wizard
- Posts: 351
- Joined: Sun Sep 03, 2006 6:32 pm
- Location: Marion, Texas
Re: Need some help!!!
The last post with the set of screen shots (three posts up) was done all in aspire with the over lapping components to make them blend in together.Phil wrote:Joe did a great job on this but I'd like to see how it could be done only using Aspire.
Joe
Thanks,
Joe
http://www.joescnc.com
Joe
http://www.joescnc.com
Re: Need some help!!!
I thought you created the ring in Solidworks.
- joecnc2006
- Vectric Wizard
- Posts: 351
- Joined: Sun Sep 03, 2006 6:32 pm
- Location: Marion, Texas
Re: Need some help!!!
The 1st set of instructions was with the STL ring file. The posts are not numbered on this forum, but i believe it is the 11th one down, the 13th, two after that shows the one all done in aspire.Phil wrote:I thought you created the ring in Solidworks.
Joe
Thanks,
Joe
http://www.joescnc.com
Joe
http://www.joescnc.com
Re: Need some help!!!
Joe, I'm still scratching my head. I know which post you are referring to but I can't figure out how you created a ring shape. Was it a two rail sweep?