Viking Mug

This section is for useful tips and tricks for Aspire
Post Reply
User avatar
scovell
Posts: 44
Joined: Sat Jul 16, 2016 4:57 pm
Model of CNC Machine: Shark CNC
Location: O Fallon, MO USA

Viking Mug

Post by scovell »

Here is a viking mug I made for game nights, renaissance festivals, octoberfests, etc.
I bought the viking face model on Etsy.

* A series of 10 rings were cut, pinned and glued together to create the mug. The bottom ring has a lip to prevent the tumbler from sliding through.
* The mug handle resembles an ax. Two rings were notched, so that the ax handle could be glued in place.
* The viking face was cut and then glued to the front of the mug. I would have liked to have cut the face directly into the mug but my machine doesn't have the height to do so.
* I used the tumbler as an insert as it keeps your cold drinks cold and your hot drinks hot. I also like that it can be removed to be washed.
mugfrontsm.png
mugandtumblersm.png
mugbacksm.png
mugring.png

User avatar
highpockets
Vectric Wizard
Posts: 3667
Joined: Tue Jan 06, 2015 4:04 pm
Model of CNC Machine: PDJ Pilot Pro

Re: Viking Mug

Post by highpockets »

I like the creativity! Nicely done....

Thanks for sharing.
John
Maker of Chips

User avatar
scovell
Posts: 44
Joined: Sat Jul 16, 2016 4:57 pm
Model of CNC Machine: Shark CNC
Location: O Fallon, MO USA

Re: Viking Mug

Post by scovell »

I apologize, I put this post in the wrong spot. I'll see if I can delete it and post it in the correct place.

User avatar
TReischl
Vectric Wizard
Posts: 4589
Joined: Thu Jan 18, 2007 6:04 pm
Model of CNC Machine: 8020 48X36X7 RP 2022 UCCNC Screenset
Location: Leland NC

Re: Viking Mug

Post by TReischl »

I really like it! Nicely done!
"If you see a good fight, get in it." Dr. Vernon Johns

User avatar
Phil
Vectric Wizard
Posts: 3026
Joined: Thu Nov 17, 2005 10:56 pm
Location: Pittsfield, MA

Re: Viking Mug

Post by Phil »

Very cool, every viking should have one.

Phil

User avatar
mtylerfl
Vectric Archimage
Posts: 5865
Joined: Thu Jan 29, 2009 3:54 am
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
Location: Brunswick, GA

Re: Viking Mug

Post by mtylerfl »

Great job, Mike! I like the design and the description/steps you used to put it all together!
Michael Tyler

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC

Post Reply