Page 1 of 1

Thickness Display

Posted: Thu Sep 12, 2019 11:27 pm
by gkas
I was just watching the newly re-released tutorial of the Double Sided Marlin. Good refresher.

I did notice one great tip that I don't remember being mentioned. On a double sided project, if you hold down the Ctrl key, the bottom right status area displays "Thickness: xxx". It calculates the material thickness at the position of the cursor. REALLY useful. :)

Re: Thickness Display

Posted: Thu Sep 12, 2019 11:57 pm
by mezalick
Good tip,
Thanks for pointing that out.
Michael

Re: Thickness Display

Posted: Fri Sep 13, 2019 6:36 pm
by SteveNelson46
It doesn't seem to work on rotary projects though.