converting a model airplane plan part to dxf ready for cutti

This section is for useful tips and tricks for Aspire
Post Reply
stankern
Vectric Wizard
Posts: 558
Joined: Tue Nov 27, 2007 3:21 pm
Location: ontario canada

converting a model airplane plan part to dxf ready for cutti

Post by stankern »

Found an old aircraft plan and thought i would trace out the stablizer and convert it to a *.dxf file then
using aspire to clean up the vectors ,size it and run it through the simulator for the cut out

Attachments
IMG_0009.JPG
IMG_0011.JPG

stankern
Vectric Wizard
Posts: 558
Joined: Tue Nov 27, 2007 3:21 pm
Location: ontario canada

Re: converting a model airplane plan part to dxf ready for c

Post by stankern »

this shows the cut also



Post Reply