<Ctrl S>, <Ctrl Alt S>, and Backups

This section is for useful tips and tricks for Aspire
User avatar
scottp55
Vectric Wizard
Posts: 3912
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP10
Location: Kennebunkport, Maine, US

Re: <Ctrl S>, <Ctrl Alt S>, and Backups

Post by scottp55 »

Stay Safe Randall!
Thinking about you.
(Family with children are across from San Fran Bay..air gets pretty bad for the kids)
scott
"Some would find fault with the morning red, if they ever got up early enough."
HDT

User avatar
Ms Wolffie
Vectric Wizard
Posts: 2695
Joined: Sat Mar 31, 2012 10:41 pm
Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
Location: Tully Heads, Wet Tropics, Queensland, Australia

Re: <Ctrl S>, <Ctrl Alt S>, and Backups

Post by Ms Wolffie »

Hi Scott
How's you doing?
Cheers
Wolffie

Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6

User avatar
scottp55
Vectric Wizard
Posts: 3912
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP10
Location: Kennebunkport, Maine, US

Re: <Ctrl S>, <Ctrl Alt S>, and Backups

Post by scottp55 »

Hey Wolffie..Long time no see :)
I was Just Starting to cut again, and had projects all lined up....
But pulled a stupid move and on bed rest for a bit :oops:
Too make the gods laugh.....Make Plans!
Ain't that the way Wolffie :)

BUT glanced at computer and saw your name on my 5 minutes out of bed and HAD to answer:)
Very good on the whole!
NICE to see your name!!!!
Be Well Wolffie!! :)
scott
"Some would find fault with the morning red, if they ever got up early enough."
HDT

User avatar
Ms Wolffie
Vectric Wizard
Posts: 2695
Joined: Sat Mar 31, 2012 10:41 pm
Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
Location: Tully Heads, Wet Tropics, Queensland, Australia

Re: <Ctrl S>, <Ctrl Alt S>, and Backups

Post by Ms Wolffie »

some mothers do have them aye?
I have missed our chats.
Cheers
Cheers
Wolffie

Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6

User avatar
scottp55
Vectric Wizard
Posts: 3912
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP10
Location: Kennebunkport, Maine, US

Re: <Ctrl S>, <Ctrl Alt S>, and Backups

Post by scottp55 »

Aah....Wolffie,
JUST tried to send you a a PM with my e-mail so we can chat again :)
But did something wrong,or mailbox too full.
I'll try again next time up.
Keep an eye out for a PM.
Cheers,
scott
"Some would find fault with the morning red, if they ever got up early enough."
HDT

Post Reply