Hi,
Need help with the installation and registration issue for my paid Aspira version. It is always shoving that I need to login, when I log in, it is showing trial version. I had reinstalled and try to install new version all over again. System sent me to the trial version directly all over again
Zack Blascak
Problem with Installation of the Aspira
- Rcnewcomb
- Vectric Archimage
- Posts: 5927
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Problem with Installation of the Aspira
Send an email to support@vectric.com and they should be able to help. This is primarily a user-to-user support forum so we have no control over the registration process.
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
- martin54
- Vectric Archimage
- Posts: 7354
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: Problem with Installation of the Aspira
You can't register a trial version of the software so don't try to use the licence you have with the trial version.
You will need to download & instal the version you have purchased. You should be able to download it from your V&Co account, while you are there then copy the licence at the same time.
Once it is installed then you can paste the licence file in
You will need to download & instal the version you have purchased. You should be able to download it from your V&Co account, while you are there then copy the licence at the same time.
Once it is installed then you can paste the licence file in
Re: Problem with Installation of the Aspira
Hi
Thank you for fast support as always!!! I didnt pay attention, which email I was using to login and register new installation. All is good.
Thank you for fast support as always!!! I didnt pay attention, which email I was using to login and register new installation. All is good.