So, I have this dish on a level as a single component, then I added the spout cutout with a sweep/rail. I have the spout component set to merge low (otherwise the spout cutout cuts deep into the dish) I then added some smoothing to it. It all worked fine except for the transition from the spout into the cup (I have that area highlighted in the picture below).
How can I make that transition much smoother ?
Selectively blending components
Re: Selectively blending components
Great idea! I actually did not try that I was hoping for something a little more uniform, but might work with some care!
- ohiolyons
- Vectric Wizard
- Posts: 1714
- Joined: Wed May 27, 2009 7:16 pm
- Model of CNC Machine: Laguna IQ
- Location: Kettering, Ohio
Re: Selectively blending components
Check out Michael Mezalick's YouTube channel to inspire your sculpting inspiration.
https://www.youtube.com/user/mezalick
https://www.youtube.com/user/mezalick
John Lyons
CNC in Kettering, Ohio
CNC in Kettering, Ohio