Updated to Aspire V11. When I go to select a tool it is greyed out and the ability to adjust feed rates etc. is not present. To work around the issue I have copied my tool db from version 10 and pasted them into the v11 toolsdatabase folder and then the tools show up properly. Attached is a picture of what I am experiencing (simple pocket that I would like to run with a .125 endmill). Just wondering what I goofed up.
Thanks.
Andy
Tool Database
- Leo
- Vectric Wizard
- Posts: 4091
- Joined: Sat Jul 14, 2007 3:02 am
- Model of CNC Machine: 1300 x 1300 x 254 Chinese Made
- Location: East Freetown, Ma.
- Contact:
Re: Tool Database
When you installed V11 there should have been a pop up asking if you wanted to migrate the tool database. Did you say yes to that?
Imagine the Possibilities of a Creative mind, combined with the functionality of CNC
-
- Posts: 22
- Joined: Thu Sep 17, 2009 4:05 pm
- Model of CNC Machine: Shark Pro
- Location: Helena, MT USA
Re: Tool Database
Yes for both the Tools Db and the Post Processors I believe...
- Adrian
- Vectric Archimage
- Posts: 14655
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Tool Database
See this thread - viewtopic.php?f=2&t=37970
What you are seeing is correct behaviour. You have to define the tool settings for the material/machine combo you are using.
What you are seeing is correct behaviour. You have to define the tool settings for the material/machine combo you are using.
-
- Posts: 22
- Joined: Thu Sep 17, 2009 4:05 pm
- Model of CNC Machine: Shark Pro
- Location: Helena, MT USA
Re: Tool Database
Thank you. I appreciate the point to the previous post. Sorry I did not see that before. I will have to mess with machine/material settings.
Thanks again.
Andy
Thanks again.
Andy